antenna

Antenna as dipole network in scattering matrix

When in past i worked with SDR hardware i experimental that noise line in space is about -100dB, when i don’t amplify RF gain, when i amplify it, it is -80dB till -20dB. So other hand when i use different antenna pick value of noise is change, today i know that a antenna is a dipole network that can describe with scattering matrix.

I read from this link . so for good transmission digital video we should use RX/TX antenna.

S-parameters describe the input-output relationship between ports (or terminals) in an electrical system. For instance, if we have 2 ports (intelligently called Port 1 and Port 2), then S12 represents the power transferred from Port 2 to Port 1. S21 represents the power transferred from Port 1 to Port 2. In general, SNM represents the power transferred from Port M to Port N in a multi-port network.

A port can be loosely defined as any place where we can deliver voltage and current. So, if we have a communication system with two radios (radio 1 and radio 2), then the radio terminals (which deliver power to the two antennas) would be the two ports. S11 then would be the reflected power radio 1 is trying to deliver to antenna 1. S22 would be the reflected power radio 2 is attempting to deliver to antenna 2. And S12 is the power from radio 2 that is delivered through antenna 1 to radio 1. Note that in general S-parameters are a function of frequency (i.e. vary with frequency).

As an example, consider the following two-port network:

two  port

Fig1: Two port network

In the above Figure, S21 represents the power received at antenna 2 relative to the power input to antenna 1. For instance, S21=0 dB implies that all the power delivered to antenna 1 ends up at the terminals of antenna 2. If S21=-10 dB, then if 1 Watt (or 0 dB) is delivered to antenna 1, then -10 dB (0.1 Watts) of power is received at antenna 2.

If an amplifier exists in the circuitry, then S21 can show gain (i.e. S21 > 0 dB). This means that for 1 W of power delivered to Port 1, more than 1 W of power is received at Port 2.

 

In practice, the most commonly quoted parameter in regards to antennas is S11. S11 represents how much power is reflected from the antenna, and hence is known as the reflection coefficient(sometimes written as gamma:  or return loss. If S11=0 dB, then all the power is reflected from the antenna and nothing is radiated. If S11=-10 dB, this implies that if 3 dB of power is delivered to the antenna, -7 dB is the reflected power. The remainder of the power was “accepted by” or deliverd to the antenna. This accepted power is either radiated or absorbed as losses within the antenna. Since antennas are typically designed to be low loss, ideally the majority of the power delivered to the antenna is radiated. See also VSWR, which is directly related to S11.

As an example, consider the plot of S11 in the following figure:

You can see S11 and S12 a RF coil in below image , i taked it from this link.

RF coil

Fig2:RF Coil S-Parameter

 

Sharing is caring!

Leave a Reply

Your email address will not be published. Required fields are marked *